PROTECTOR GP-SIDEBAR 1013083 - Caterpillar

Illustration 36 g06273178
Install pressure switch (18) on cleaner and route jumper harness (32).Note: Hand tighten until switch is in contact with the air cleaner and then apply extra 1/4 turn.
Illustration 37 g06273180
Install ladder clip (3) using washer (8), bolt (11), and strap (6).
Secure harness (32) to cleaner body using two cable ties (19).
Use tie (25) to attach harness jumper to cleaner body.
Illustration 38 g06273183
Route the antenna wires as shown in Illustration .Note: Ensure that minimum wire bend radius after installation is 51 mm (2.01 inch).
Illustration 39 g06273189
Install ladder clip (4) and cable ties (19). Keep existing strapping point (P1).
Illustration 40 g06273719
Illustration 41 g06273723
Install two cable tie mountings (24) using two washers (8), two bolts (9), and two straps (2).
Illustration 42 g06273743
Connect and route temperature sensor harness jumper (32) using ladder clip (4), bolt (11), washer (8), and three straps (2).
Illustration 43 g06273747
Illustration 44 g06274474
Secure temperature sensor (17) and harness jumper (32) to ladder clip using cable strap (2).
Illustration 45 g06274476
Install strap (19).
Illustration 46 g06274485
Reposition hood on the machine. Check antenna clearance with coolant hose.
Illustration 47 g06274489
Connect pressure switch harness to harness (H).
Illustration 48 g06274492
Connect air duct (28) using clamp (12) on the cleaner side and clamp (15) on the turbo side.Note: Check duct clearance with engine tubes.
Illustration 49 g06274494
Reconnect exhaust flex pipe and complete hood reinstall procedure.
Start engine.
Check for exhaust flex pipe leaks.
Engine at Low Idle
Engine at High Idle
Engine Stall
Flash new 516-7992 Engine Software.Note: The new software is available in the form of a flash file through the Caterpillar Service Information System (SIS). A newer part number may be available. SIS Web only displays the latest available flash file.
Connect to Cat® Electronic Technician (Cat ET) and check for no codes.