PROTECTOR 2008607 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1P-0520 Driver Gp 1 Start By:
Remove the center drive shaft.
Illustration 1 g00682886
Remove bolt (1) and retainer (2) from the splined end of the front drive shaft.
Illustration 2 g00682895
Remove O-ring seal (3) and yoke assembly (4).
Illustration 3 g00682896
Support front drive shaft (6) with a suitable floor jack, as shown.
Remove four bolts (5).
Separate the universal joint.
Illustration 4 g00682897
Remove six bolts (7), the washers, and the nuts that hold bearing cage (8) to the front main frame.
Illustration 5 g00682898
Remove two bolts (9) and bearing cage (8).
Illustration 6 g00682899
Remove O-ring seal (10).
Illustration 7 g00682901
Install two M12 X 1.75 forcing screws in bearing cage (11).
Remove bearing cage (11).
Remove front drive shaft (6). The weight of front drive shaft (6) is 60 kg (135 lb).
Illustration 8 g00682902
Use a suitable press and Tooling (A) in order to remove the roller bearing from bearing cage (11).
Remove the lip seal from bearing cage (11).
Illustration 9 g00682941
Remove the lip seal (12) from bearing cage (8). Installation Procedure
Install front drive shaft (6) in the reverse order of removal.