PULLER GP 1296675 - Caterpillar

Illustration 1 g01633013
(2) Bucket cylinder group (3) Stick cylinder group (4) Bucket linkage group (5) Bucket group (6) Boom groupNote: All bores must be free of paint. Use 5P-0960 Grease Cartridge in order to coat all bores for the pins, the bucket and the cylinder pin bores. (1) Assemble the stick cylinder so that the grease zerk is directed, as shown.Note: Install the following sleeve bearings in the bore so that the part number of each sleeve bearing is facing outward. (7) The sleeve bearing is one of the following part numbers: 236-8561 Sleeve Bearing Quantity ... 2 Inside diameter ... 120.20 0.02 mm (4.732 0.001 inch) Outside diameter ... 140.198 0.011 mm (5.5196 0.0004 inch) Installation depth of the sleeve bearing ... 9.5 0.8 mm (0.37 0.03 inch) 228-5621 Sleeve Bearing Quantity ... 2 Inside diameter ... 120.32 0.04 mm (4.737 0.002 inch) Outside diameter ... 140.260 0.013 mm (5.5220 0.0005 inch) Installation depth of the sleeve bearing ... 9.5 0.8 mm (0.37 0.03 inch) (8) 4I-6897 Sleeve Bearing Quantity ... 2 Inside diameter ... 80.25 0.02 mm (3.159 0.001 inch) Outside diameter ... 95.180 0.013 mm (3.7472 0.0005 inch) Installation depth of the sleeve bearing ... 9.5 0.8 mm (0.37 0.03 inch) (9) 228-5619 Sleeve Bearing Quantity ... 2 Inside diameter ... 110.30 0.04 mm (4.343 0.005 inch) Outside diameter ... 130.240 0.013 mm (5.1275 0.0005 inch) Installation depth of the sleeve bearing ... 9.5 0.8 mm (0.37 0.03 inch) (10) 148-3386 Pin As Quantity ... 2 Pin diameter ... 89.850 0.025 mm (3.5374 0.0010 inch) Bore diameter for the pin assembly ... 90.043 0.043 mm (3.5450 0.0017 inch) (11) Lubricate the sealing lip of six lip type seals lightly with the lubricant that is being sealed. Install the dust seal so that the lip faces outside, as shown. Install six lip type seals so that the lip of the lip type seals do not extend beyond the face of the boss.