PULLER AS-BRG 1H3110 - Caterpillar

Illustration 1 g00505498
(1) Bearing The bore of the bearing in the gear after installation is the following dimension. ... 63.602 0.038 mm (2.5040 .0015 inch) The diameter of the bearing surface on the shaft is the following dimension. ... 63.500 0.013 mm (2.5000 .0005 inch) (2) Studs Tighten the three studs to the following torque. ... 35 5 N m (26 4 lb ft) (3) Bearing installation depth Install the bearing from the face of the gear to the following depth. ... 1.5 0.5 mm (.06 .02 inch) (4) Front spacer plate (5) Studs Tighten the three studs to the following torque. ... 35 5 N m (26 4 lb ft) (6) Gear Length of the gear ... 50.75 0.05 mm (1.998 .002 inch) The length of the bearing surface on the shaft is the following dimension. ... 51.00 0.05 mm (2.008 .002 inch) (7) The rear face of the front housing