PULLER AS 3727975 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 9S-9082 Engine Turning Tool 1 Start By:
Remove the engine oil pump. Refer to Disassembly and Assembly, "Engine Oil Pump - Remove".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01149484
Use Tooling (A) to rotate the crankshaft in order to gain access to the piston cooling jet.
Remove bolt (1) and piston cooling jet (2). Installation Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
A 9S-9082 Engine Turning Tool 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 2 g01149484
Use Tooling (A) to rotate the crankshaft in order to gain access to the piston cooling jet.
Position piston cooling jet (2) in the cylinder block. Install bolt (1). Tighten the bolt to a torque of 25 6 N m (18 4 lb ft). End By:
Install the engine oil pump. Refer to Disassembly and Assembly, "Engine Oil Pump - Install".