PULLER G- 6V7020 - Caterpillar

6V7020 PULLER G- Caterpillar parts

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA6V7020
6V-7020
6V7020

Weight: 9 pounds 4 kg.

Buy PULLER G- 6V7020 Caterpillar genuine, new aftermarket tractor parts with delivery

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below

CATERPILLER CAT 6V7020 Nozzle Puller Group with Accessories

$499.00

15 Aug 2020

-: -

CATERPILLER CAT 6V7020 Nozzle Puller Group with Accessories
✔ USED - An item in perfect working condition. Instructions are included. || ✔ Price: Buyers are free to make an offer using "contact seller" tab on amazon product page. We will proceed/reply if we agree/do not agree the price. If agreed, we will update the price in our listing and we will reply to the buyer so that the buyer can place the order at agreed price. || ✔ ORIGINAL IMAGES OF THE ACTUAL PRODUCT ARE UPLOADED, Please refer closely. We accept returns only if the item was not as described in the listing. || ✔ Shipping :- CUSTOM DUTY AND CHARGES ARE TO BE PAID BY THE BUYER AT THEIR DESTINATION COUNTRY. PLEASE CHECK WITH YOUR COUNTRY'S CUSTOMS OFFICE TO DETERMINE WHAT THESE ADDITIONAL COSTS WILL BE PRIOR TO BUYING. If your area is not serviceable by our logistic partners, we will refund the money. || ✔ We do our best to present accurate, detailed information about every item we sell. If you have any questions, Please contact us before Buying. If you are unhappy for any reason please contact us before leaving the feedback. Your feedback is important to us.

Show more prices Caterpillar parts

This part in 1 request: Show. This information for suppliers only!

#769501 6V7020

2021-12-06

For full view, you need register

Information:

Illustration 1 g00877820
Schematic Of Sensor Power Supply Voltage
The sensor supply is a power supply that is internal to the ECM. The sensor supply provides +8 DCV in order to operate the sensors.This diagnostic code will be recorded when the transmission ECM reads the voltage for the circuit of the sensor supply as being above normal.The results of this diagnostic code are listed:
All of the associated sensors will also log faults.The possible causes of the diagnostic code are listed:
+8 DCV (wire 799-CF4-WH(White)) is shorted to the +battery in the machine harness.
The ECM has failed. This is unlikely.Test Step 1. CHECK FOR A SHORT TO THE +BATTERY.
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness from the ECM.
At the machine harness connectors for the ECM, measure the resistance between the contact for the +battery and the contact for the sensor supply voltage. See the schematic for more detailed information about the sensor power supply voltage for the sensor that is being tested. Expected Result:The resistance that is measured is greater than 5000 ohms.Results:
OK - The resistance that is measured is greater than 5000 ohms. The harness circuit is correct. The ECM may have failed.Repair: It is unlikely that the ECM has failed. Perform this diagnostic code procedure again. Replace the ECM if the cause of the diagnostic code is NOT found. See Testing and Adjusting, "Electronic Control Module (ECM) - Replace". STOP
NOT OK - The resistance measures less than 5000 ohms. The machine harness has failed.Repair: There is a short between the +battery circuit and the circuit for the sensor power supply in the machine harness. Repair the machine harness or replace the machine harness.STOP