PULLEY-ALTERNATOR 1869375 - Caterpillar

1869375 PULLEY-ALTERNATOR Caterpillar parts R1300, R1300G

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA1869375
186-9375
1869375

Weight: 2 pounds 1 kg.

Buy PULLEY-ALTERNATOR 1869375 Caterpillar genuine, new aftermarket tractor parts with delivery
LOAD HAUL DUMP,

Compatible equipment models: 1869375:

LOAD HAUL DUMP R1300 R1300G Caterpillar

Number on catalog scheme: 13

Caterpillar 1869375 Parts scheme PULLEY-ALTERNATOR

For full view, you need register

Information:

Remove retaining ring (14).
Illustration 8 g00702583
Use two people to remove ring gear (15) from housing (16). The weight of ring gear (15) is approximately 29 kg (65 lb).
Illustration 9 g00702584
Remove spacer (17) from carrier assembly (18).
Illustration 10 g00702596
Remove retaining ring (19).
Illustration 11 g01338951
Attach a suitable lifting device to carrier assembly (18). The weight of carrier assembly (18) is approximately 25 kg (55 lb).
Remove carrier assembly (18).
Illustration 12 g00702640
Drive roll pin (20) into shaft (21).
Remove shaft (21).
Illustration 13 g00702648
Disassemble the gear assembly in the following order: washer (22), bearing (23), gear (24), bearing (25), and washer (26). Remove roll pin (20) from shaft (21).
Repeat Step 15 through Step 17 for the remaining gear assemblies.
Illustration 14 g01339732
Remove bolts (27).
Illustration 15 g06093993
Illustration 16 g06094022Note: If shaft assembly (29) is stuck in housing (28), use Tooling (B) to remove shaft assembly (29).
Attach Tooling (A) and a suitable lifting device to housing (28). The weight of housing (28) is approximately 68 kg (150 lb).
Remove housing (28).
Illustration 17 g06094046
Illustration 18 g06094049
Illustration 19 g06094050
Install retaining ring (19).
Attach a suitable lifting device to shaft assembly (29). The weight of shaft assembly (29) is approximately 45 kg (100 lb).
Position shaft assembly (29) onto Tooling (D). Install Tooling (C).
Position Tooling (D) and shaft assembly (29) as a unit into a suitable press. The weight of Tooling (D) and the shaft assembly (29) is approximately 93 kg (205 lb).
Remove retaining ring (19), bearings (30), and spacer (31).Note: If excessive force is required to remove bearings, use Tooling (E) to remove the top bearing first.
Illustration 20 g06094057
Attach a suitable lifting device to Tooling (C) to remove cage (33) and Tooling (D). Remove cage (33) and Tooling (D) from shaft (32).
Illustration 21 g01340053
Remove O-ring seal (34) and lip seals (35).