PULLEY AS-IDLER 1979642 - Caterpillar

Uninterruptible Power Supply: UPSB 125 (S/N: SEP1-UP) UPSB 130 (S/N: XTC1-UP)Introduction
This Special Instruction covers the installation and configuration of the UPS Network Management Card.Do not perform any procedure and do not order parts that are outlined in this publication until you understand the information that is contained in this document.Important Safety Information
Work safely. Most accidents that involve product operation, maintenance, and repair are caused by failure to observe basic safety rules or precautions. An accident can often be avoided by recognizing potentially hazardous situations before an accident occurs.A person must be alert to potential hazards. This person should also have the necessary training, skills, and tools in order to perform these functions properly.Safety precautions and warnings are provided in this instruction and on the product. If these hazard warnings are not heeded, bodily injury or death could occur to you or to other persons. Caterpillar cannot anticipate every possible circumstance that might involve a potential hazard. Therefore, the warnings in this publication and the warnings that are on the product are not all inclusive. If a tool, a procedure, a work method or operating technique that is not specifically recommended by Caterpillar is used, you must ensure that it is safe for you and for other people to use. You should ensure that the product will not be damaged or the product will be made unsafe by the operation, lubrication, maintenance or the repair procedures that are used.Environment
This product complies with the most strict regulations. This product does not contain CFCs or HCFCs.Packing materials were selected to facilitate recycling. Please make sure they are correctly recycled in compliance with all applicable regulations.Special Precautions
If the card must be stored prior to installation, storage must be in a dry place. The admissible storage temperature range is −10° to 70°C (14° to 126°F).Compatibility
When correctly installed and used in accordance with the manufacturer's instructions, the network management card complies with the following standards:
ATI safety: EN60950/A11 (1998)
EMC: EN61000-6-2 (1999), EN 61000-6-3 (2002)Conformity with European directives:
Low Voltage 73/23/EEC and 93/68/EEC
EMC: 89/336/EEC and 93/68/EECFederal Communication Commission (FCC) Statement
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.Unpack and Check Contents
Network Management Card Transverse
Illustration 1 g02064513
Network Management Card Transverse
A network management card transverse communication card with a standard front plate already installed
A serial communication cable used for configuration and maintenance
Installation and configuration instructions
The Solution Pac 2 CD ROMOverview
Network Management Card Transverse
Illustration 2 g02064521
(1) Jumper for return to the default password (2) Labels for