PULLEY GP 2115964 - Caterpillar

2115964 PULLEY GP Caterpillar parts 330C, 330C L, C-9

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA2115964
211-5964
2115964

Buy PULLEY GP 2115964 Caterpillar genuine, new aftermarket tractor parts with delivery
EXCAVATOR, MOBILE HYD POWER UNIT,

Compatible equipment models: 2115964:

EXCAVATOR 330C 330C L

INDUSTRIAL ENGINE C-9

MOBILE HYD POWER UNIT 330C Caterpillar

Number on catalog scheme:

Caterpillar 2115964 Parts scheme PULLEY GP

For full view, you need register

Information:

Illustration 12 g01472936
The fixture is set up in order to rework the right bracket. (M) If you are using a hand drill to perform this rework then cut the plate to 100 mm long dimension (M). See Table 7. (Y) The locator is attached to the rear of the plate when the fixture is attached to the bracket. (CC) Bolts that hold the drill guide to the adapter plate 6V-5684 Bolts (EE) This hole of the fixture is toward the bottom edge and on the side that is toward the tractor when the fixture is mounted on the right hand bracket.
Then reassemble the two components of the fixture by using two 6V-5684 Bolts (DD). Tighten two 6V-5684 Bolts (DD). The above plate is set up in order to drill the lower hole that is located on the right bracket for the apron.
Assemble the drill fixture in order to rework the right side of the right bracket. Make sure that hole (EE) is on the bottom and on the side toward the tractor. Fasten the plate assembly to the right bracket by using the two 6V-3823 Bolts (CC) and the two locators (Y) .
Illustration 13 g01479292
Drill holes (EE) only.The fixture is mounted on the right bracket. Please note the location of the hole pattern to the bottom of the bracket.
Mount the fixture on the right bracket and drill two holes (EE) by using the 1U-8169 Drill Bit .
Remove the fixture and tap the two holes by using the 8T-3091 Tap .
Illustration 14 g01473966
A