PULLEY GP 2P8605 - Caterpillar

(75V, 01Z) MARINE ENGINESProblem:
There have been reports of oil leaking around the studs that hold the oil cooler to the base. Solution:
Three studs (1), three nuts (2), and three washers (3) are used to fasten the oil cooler (5) to the base (4). See the illustration. Use the procedure that follows on one of the studs at a time.1. Remove one nut (2) and washer (3) from one of the studs (1).2. Thoroughly, clean any oil and dirt from the area around the stud.3. Apply 4C-9614 RTV Sealant (Red) to the threads of the stud (1).4. Install a 5L-5840 Washer Seal, a 5M-2894 Washer (3), and a 1D-4717 Nut (2) on the stud (3).5. Tighten the nut (2) to a torque of 22 3 N m (16 2 lb ft).6. Repeat Steps 1 through 5 for each of the remaining studs (1).
FRONT VIEW ON 1W-4914 ENGINE OIL COOLER GROUP Studs (1). 1D-4717 Nut (2). 5M-2894 Washer (3). Base (4). Oil Cooler (5). Cover (6).COPYRIGHT 2001 CATERPILLAR ALL RIGHTS RESERVED