PULLEY 4L2885 - Caterpillar

Turn the battery disconnect switch to the OFF position.
Open the left door.
Illustration 1 g00643794
Remove four bolts (1) .
Illustration 2 g00643804
Loosen two bolts (3) on the top of panel (2) .
Remove panel (2) .
Illustration 3 g00643809
Slide back boot (4).
Illustration 4 g00643844
Remove nut (10) .
Open the cap, and loosen screw (7) .
Disconnect wires (5), (6), (8), and (9) .
Illustration 5 g00643854
Remove two bolts (11) .
Disconnect wire (12) .
Illustration 6 g00643860
Remove bolt (13) .
Remove electric starting motor (14) .Installation Procedure
Accidental machine starting can cause injury or death to personnel working on the machine.To avoid accidental machine starting, turn the battery disconnect switch to the OFF position and remove the key. If the machine is not equipped with a battery disconnect switch, disconnect the battery cables from the battery and tape the battery clamps.Place a do not operate tag at the battery disconnect switch location to inform personnel that the machine is being worked on.
Illustration 7 g00643860
Place electric starting motor (14) in position.
Install bolt (13) .
Illustration 8 g00643854
Connect wire (12) .
Install two bolts (11) .
Illustration 9 g00643844
Connect wires (5), (6), (8), and (9) .
Tighten screw (7) and close the cap.
Install nut (10) to a torque of 21.0 3.5 N m (186 31 lb in).
Illustration 10 g00643809
Slide boot (4) over the connection.
Illustration 11 g00643804
Place panel (2) in position.
Tighten two bolts (3) .
Illustration 12 g00643794
Install four bolts (1) .
Close the left door.
Turn the battery disconnect switch to the ON position.End By: Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect" for the proper procedure.