PULLEY 5S8168 - Caterpillar

On-Highway Transmission:
CX35 (S/N: W3X1-UP)
Petroleum Power Train Package:
CX35-P800-C18I (S/N: PCF1-UP; PCZ1-UP)
Petroleum Transmission:
CX35-P800 (S/N: TRJ1-UP)
Service Magazine, SEPD1749, 05 March 2014, "Improved Torque Converter Housings Are Now Used on Certain On-Highway Transmissions, Petroleum Transmissions, and Petroleum Power Train Packages". Disregard this article. See the article that follows for the correct effectivity.Description of Change: New torque converter housings are now used that improve the sealing properties of the o-ring seal between the torque converter housing and relief valve separator plate.Adaptable To:
Table 1
Parts List    
Model    Qty    New Part Number    Description    Former Part Number    
TRJ     1     399-5867     Torque Converter Housing     304-9044    
W3X     1     399-5875     Torque Converter Housing     292-4351    The new torque converter housings are effective in production with the following Transmissions and Petroleum Power Train Packages:
CX35-P800-C18I Petroleum Power Train Package (S/N: PCF115-UP; PCZ153-UP)
CX35-P800 Petroleum Transmission TRJ597-UP
CX35 On-Highway Transmission W3X380-UPThe new torque converter housings are adaptable with the following Transmissions and Petroleum Power Train Packages:
CX35-P800-C18I Petroleum Power Train Package (S/N: PCF1-114; PCZ1-152)
CX35-P800 Petroleum Transmission TRJ1-596
CX35 On-Highway Transmission W3X1-379Rework Instructions for the Current Housings
Note: If a leak occurs during lockup clutch engagement when using the 292-4351 Torque Converter Housing or the 304-9044 Torque Converter Housing, complete the following procedure.
Table 2
Sealant    
Item    Qty    Part Number    Description    
1     (1)     169-5464(Loctite® Item Number 21348)     Quick Cure Primer    
2     (2)     4C-5300(Loctite® Item Number 17430)     Gasket Sealant    
( 1 ) Loctite® 7649 Primer N
( 2 ) Loctite® 5127 Flexible Anaerobic Gasket Flange Sealant
Illustration 1 g03640156
Typical Example
Thoroughly clean the surfaces at location (A) and location (B).
After the parts are clean and dry apply Loctite® Primer (1) to separator plate (3) and location (A) .Note: Make sure to get the Loctite® Primer all around the bolt clearance holes as shown at location (C) .
Let the Loctite® Primer dry.
Then apply Loctite® (2) to separator plate (3) and location (A) .Note: Specifically apply sealant to the circled landings around the bolt holes as shown in location (C). Sealant applied toward the inside of the o-ring groove on separator plate (3) is acceptable. Do not apply sealant down inside of the o-ring groove.
Install the o-ring seal to separator plate (3),
Immediately assemble separator plate (3) to the torque converter housing.
Tighten the bolts to normal torque.
Allow time for the Loctite® to cure before pressurizing.