PULLEY 6N1705 - Caterpillar

Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed. The user is responsible for the performance of maintenance, including all adjustments, the use of proper lubricants, fluids, and filters. The user is also responsible for the replacement of components due to normal wear and aging. Failure to adhere to proper maintenance intervals and procedures may result in diminished performance of the product and/or accelerated wear of components. Use fuel consumption, service hours, or calendar time, WHICH EVER OCCURS FIRST, to determine the maintenance intervals. Products that operate in severe operating conditions may require more frequent maintenance. Before each consecutive interval is performed, all maintenance from the previous interval must be performed.When Required
Battery - Recycle
Battery - Replace
Battery or Battery Cable - Disconnect
Coolant Sample (Level 2) - Obtain
Engine Air Cleaner Element - Clean/Replace
Generator - Dry
Generator Set - Test
Generator Set Alignment - Check
Generator Winding - Test
Overhaul Considerations
Stator Winding Temperature - Test
Throttle Control Valve - Check
Varistor - Inspect
Daily
Coolant Level - Check
Coolant Level - Check
Engine Air Cleaner Differential Pressure - Check
Engine Oil Filter Differential Pressure - Check
Engine Oil Level - Check
Fuel Filter Differential Pressure - Check
Fumes Disposal Filter Differential Pressure - Check
Generator Bearing Temperature - Test/Record
Generator Load - Check
Jacket Water Heater - Check
Power Factor - Check
Voltage and Frequency - Check
Walk-Around Inspection
Every 250 Service Hours
Battery Electrolyte Level - Check
Coolant Sample (Level 1) - Obtain
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Oil Sample - Obtain
Fumes Disposal Filter - Drain
Space Heater - Test
Every 1000 Service Hours
Alternator - Inspect
Belts - Inspect/Adjust/Replace
Crankcase Pressure - Measure
Crankshaft Vibration Damper - Inspect
Engine Crankcase Breather - Clean
Fumes Disposal Filter Element - Inspect
Hoses and Clamps - Inspect/Replace
Inlet Air System - Check
Nitrogen Oxide Sensor - Calibrate
Water Pump - Inspect
Every 2000 Service Hours
Engine Oil and Filter - Change
Generator Bearing - Lubricate
Generator Set Vibration - Inspect
Stator Lead - Check
Every 4000 Service Hours
Crankcase Blowby - Test/Record
Cylinder Pressure - Test/Record
Engine Mounts - Inspect
Engine Protective Devices - Check
Engine Valve Lash and Bridge - Check
Fuel Metering Valve - Check
Ignition System Timing - Check/Adjust
Starting Motor - Inspect