PULLEY 7W0498 - Caterpillar

Illustration 1 g02557779
Schematic of the action alarmThis diagnostic code is associated with the action alarm. The FMI 05 means that the Advisor has determined that the current of the alarm is below normal. The possible causes of this diagnostic code are listed below:
The energize circuit of the alarm is open.
The return circuit of the alarm is open.
The alarm has failed.
The Advisor has failed. An Advisor failure is unlikely. Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 0271 FMI 05 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.System Response:A warning will be displayed on the Advisor. The Advisor will have no control over the alarm circuit.Test Step 1. CHECK THE ALARM.
Turn the disconnect switch and the key start switch to the ON position. Do not start the engine.
Disconnect the alarm with the active diagnostic code from the machine harness.
At the machine harness connector for the alarm, place a jumper wire from contact + (wire 410-WH) to contact - (wire J847-GN).
Observe the status of the CID 0271 FMI 05.Expected Result:The CID 0271 FMI 05 remains active. The FMI has not changed and the "05" is still active.Results:
YES - The diagnostic code remains active. The jumper wire does not affect the diagnostic code. Proceed to Test Step 2.
NO - The diagnostic is no longer active. The alarm has failed.Repair: The alarm has failed. Repeat this Test Step "CHECK THE ALARM" in order to verify the failure of the alarm. Replace the alarm. Verify that the new alarm corrects the problem.STOPTest Step 2. CHECK THE HARNESS FOR AN OPEN.
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness connectors from the Advisor.
The jumper wire that was installed in the previous Test Step remains in place.
At the machine harness connector, measure the resistance from signal contact 54 (wire 410-WH) to contact 55 (wire J847-GN).Expected Result:The resistance is less than 5.0 ohms.Results:
OK - The resistance is less than 5.0 ohms. The machine harness is correct. Proceed to Test Step 3.
NOT OK - The resistance is greater than 5000 ohms. The resistance measurement is not correct. There is an open circuit in the machine harness.Repair: The open is in wire 410-WH or in wire J847-GN of the machine harness. Repair the machine harness or replace the machine harness.STOPTest Step 3. CHECK IF THE DIAGNOSTIC CODE REMAINS.
Inspect the contacts of the harness connectors and clean the harness connectors.
Reconnect all harness connectors.
Turn the disconnect switch and the key start switch to the ON position.
Operate the machine.
Check the status of the CID 0271 FMI 05.Expected Result:The CID 0271 FMI 05 is active. Results:
YES - The CID 0271 FMI 05 is active. The diagnostic code has not been corrected. The Advisor may have failed.Repair: An Advisor failure is unlikely. Exit this procedure and perform this procedure again. If