PUMP GP-WATER 0R1003 - Caterpillar

System Operation Description:The following information must be known and recorded for paralleling operations. The information must be obtained at various load points. The information must match the generator readings.
Verify breaker outputs voltage
Current
Cower
Power factor readingsThe following are what is expected:
Voltages are close to rated values
Readings from the EMCP and the CDVR match
No voltage exists on the output of the open breaker
Metering at various load points match the power analyzer readings
Metering at the output of breaker matches metering at input of breaker for paralleling
All power readings are positiveIf the expected data is not correct, then the following must be confirmed:
Confirm that the configuration is correct for the EMCP generator current transformers and the potential transformers
Ensure that settings in the EMCP and the CDVR match
Check for correct wiring.
If negative kW is seen, check for correct CT polarityA non-adjustable and non-programmable shutdown immediately occurs when the generator breaker is closed and there is a generator sensing fault. This shutdown occurs when a phase difference (non-zero) between phase A on the generator and phase A on the bus is detected. An immediate shutdown test also occurs for the other phases.Test Step 1. Hardwire Load Sense Load Demand (HWLSLD) Line Wiring FaultConfirm the status of the HWLSLD line. Table 1 lists the invalid HWLSLD inputs that generate an LSLD diagnostic.
Table 1
HWLSLD Inputs Diagnostic Truth Table
Disable LSLD Input (HWLSLD #1) Overload Input (HWLSLD #2) Excess Input(HWLSLD #3) Ramping Input(HWLSLD #4) Condition Description Diagnostic Check Response
while LSLD is Disabled
0 0 0 0 LSLD Off State Warning
0 0 0 1 Possible State – Ramping Warning
0 0 1 0 Possible State - Excess Condition Warning
0 0 1 1 Possible State - Excess and Ramping Warning
0 1 0 0 Possible State - Overload Condition Warning
0 1 0 1 Possible State - Overload and Ramping Warning
0 1 1 0 Undesirable state Warning
0 1 1 1 Unacceptable State Warning
1 0 0 0 LSLD Disabled State No Action
1 0 0 1 Unacceptable State - HWLSLD Line Fault Warning
1 0 1 0 Unacceptable State - HWLSLD Line Fault Warning
1 0 1 1 Unacceptable State - HWLSLD Line Fault Warning
1 1 0 0 Unacceptable State - HWLSLD Line Fault Warning
1 1 0 1 Unacceptable State - HWLSLD Line Fault Warning
1 1 1 0 Unacceptable State - HWLSLD Line Fault Warning
1 1 1 0 Unacceptable State - HWLSLD Line Fault Warning Expected Result:There are no arbitration line wiring faults.Results:
OK - No HWLSLD line wiring faults are present. Procee