PUMP GP-HYD 10R2861 - Caterpillar

17. Make sure the horn, back-up alarm (if equipped), lights, guards, shield, etc., are in proper working order.Window Cleaning
Use commercially available window cleaning solutions to clean the windows.It is recommended that the outside of the cab windows be cleaned from the ground level. Use an appropriate length of wood or aluminum with a soft cloth or sponge attached so that the windows can be cleaned without climbing on the machine.Remove the rear window by lifting the latch and sliding the window to the full open position. Lift the window out of the track to remove.Seat Belt
Inspect for Wear or Damage
Seat belt and mounting hardware must be inspected for wear or damage before operating the machine. Replace the belt or mounting hardware if worn or damaged.Replace the seat belt after three years of usage, regardless of appearance.Engine Crankcase
Check Oil Level
Do not overfill the crankcase. Engine damage can result.
1. Open the access cover (if equipped) on the left side of the machine. 2. Maintain oil level between the ADD and FULL marks on dipstick (1) with the engine running.Maintain the oil level between LOW and FULL marks on the engine stopped side of dipstick (1) with the engine stopped. When operating on severe slopes, the oil level in the engine crankcase must be at the FULL mark on the engine stopped side of the dipstick. 3. Remove oil fill plug (2) and add oil if necessary.4. Clean and install the fill plug.5. Close the access cover.Transmission
Check Oil Level
1. Open the access cover (if equipped) on the left side of the machine. 2. Maintain the oil between the LOW and FULL marks on dipstick (1) at LOW IDLE with the oil at operating temperature. When operating on severe slopes, additional oil is needed in the powertrain. Refer to information in the footnote in the Refill Capacities chart in the Maintenance Section of this manual.3. Remove oil fill cap (2) and add oil if necessary.4. Clean and install the fill cap.Replace the filter element if the cab transmission oil filter indicator comes on during operation. See the topic Transmission Oil Filter under Every 250 Service Hours or Monthly in the Maintenance Section of this manual.5. Close the access cover.Hydraulic Tank
Check Oil Level
The hydraulic oil tank is located on the right rear of the machine. 1. Maintain the oil level to the FULL mark on sight gauge (1). 2. Remove oil fill cap (2) and add oil, if necessary, through the fill tube.3. Clean and install the fill cap.Radiator
Check Coolant Level
1. Remove the radiator cap slowly to relieve pressure.2. Maintain the coolant level to within 13 mm (.50 in) of the bottom of the fill pipe. If it is necessary to add coolant daily, check for leaks.3. Inspect the cap and cap seal for damage, deposits or foreign material. Clean the cap with a clean cloth or replace the cap if it is damaged.4. Install the cap.5. Inspect the radiator core for debris and clean if necessary.Compressed air is preferred, but high pressure