PUMP GP-PS-V-C 10R3589 - Caterpillar

Removal Procedure
Reference: Special Instruction, "Visual Service Procedures - Colors and Symbols" M0066576.
Table 1
Required Tools
Tool Part Number Part Description Qty
A(1) 9U-6198 Crankshaft Turning Tool 1
A(2) 9U-7336 Housing 1
5P-7305 Engine Turning Tool 1
(1) The Crankshaft Turning Tool is used on the front pulley.
(2) This Tool is used in the aperture for the electric starting motor.Start By:
Remove the engine oil pump.Note: Either Tooling (A) can be used. Use the Tooling that is most suitable.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
If the crankshaft is installed, use Tooling (A) to rotate the crankshaft to gain access to the piston cooling jet.
Illustration 1 g06278294
Illustration 2 g06278298
Illustration 3 g06278305Installation Procedure
Clean the piston cooling jets and inspect the piston cooling jets for damage. Ensure that the valve is free to move within each piston cooling jet. Replace any damaged piston cooling jets. The procedure for checking that the alignment of the piston cooling jets is described in Specifications, "Piston Cooling Jet Alignment" for more information.
If the crankshaft is installed, use Tooling (A) to rotate the crankshaft to access the mounting flange for the piston cooling jet.
Illustration 4 g06278318
Illustration 5 g06280017Note: Ensure that the piston cooling jet is correctly installed into the oil passage in the cylinder block before tightening the bolt.
Illustration 6 g06280020End By:
Install the engine oil pump.