PUMP GP-GR 2 BSC 10R6196 - Caterpillar

Bulldozer Blade Tilt (if equipped)
The blade can be tilted to various angles with the following instructions. 1. Pull the lever to TILT LEFT to lower the left side of the blade.2. Move the tilt lever to HOLD to stop the blade movement.3. Push the lever right to TILT RIGHT to lower the right side of the blade.Bulldozer Blade Tip
The blade can be tipped to various angles with the following instructions. 1. Lengthen both braces to tip the blade FORWARD.2. Shorten the braces to tip the blade BACK. 3. Lengthen the hydraulic cylinder (if equipped) to tip the blade FORWARD.4. Shorten the hydraulic cylinder to tip the blade BACK.Bulldozer Blade Angling
The blade can be positioned to various angles with the following instructions. 1. Remove the lock pin from the retainer pin. (One on each side.) 2. Remove the coupling retainer pins. 3. Pull the coupling pin out of the housing. 4. Position the blade at the desired angle. 5. Install the coupling pins in the new positions.6. Install the coupling retainer pins.7. Install the lock pins.Tracks
If tracks are too tight or too loose, wear of components is accelerated. If they appear too tight or too loose, have the track adjusted. Follow the procedures in the "Maintenance Section" of this manual for adjustment.
Ripper Tips (if equipped)
Replace ripper tips before wear occurs on the shank. Follow the procedures in the "Maintenance Section" of this manual for replacement.Cutting Edges and End Bits
Replace or reverse the cutting edges or end bits, before wear occurs on the blade base. Follow the procedures in the "Maintenance Section" of this manual for replacement.