PUMP GP- HYD 10R6275 - Caterpillar

Machine Stopping
With the engine stopped, parking brake must be applied to prevent machine from moving.
1. Move the governor control lever to the low idle position to reduce the engine speed. 2. Apply both service brake pedals to stop the machine. 3. Push the flywheel clutch pedal down to disengage the flywheel clutch. 4. Engage the parking brake. Release the service brake pedals. 5. Move the transmission speed control lever to NEUTRAL. 6. Move the transmission direction control lever to NEUTRAL.7. Lower all attachments to ground and apply slight down pressure.Freezing Conditions
If freezing temperatures are expected, each track roller frame should be cleaned of mud and dirt and the machine parked on wood planks. Clean in and around the carrier rollers.Stopping the Engine
Stopping the engine immediately after it has been working under load, can result in overheating and accelerated wear of the engine components. Follow the stopping procedure outlined below to allow the engine to cool properly.
Never turn the electrical disconnect key switch off while the engine is running. 1. With the machine stopped, see topic "Stopping the Machine" in the "Machine Parking" section of this manual. Operate the engine for 5 minutes at low idle.This allows hot areas in the engine to cool gradually, extending engine life. 2. Move the governor control lever all the way forward to stop the engine. 3. Turn the electrical disconnect switch off. 4. Use the step and handholds, use both hands and face the machine, when dismounting. 5. Inspect the engine compartment for debris. Clean out any debris or paper to avoid a fire.6. If the machine is being parked for an extended period (overnight, etc.), remove the electrical disconnect switch key. 7. Install all vandalism protection locks and covers.