PUMP GP-GR 2 BSC 10R7115 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     4C-9614     Silicone Sealant     1    
Refer to Operation and Maintenance Manual, "Engine Oil and Filter - Change" for the proper draining and filling procedures.
Illustration 1 g02859716
Remove bolts (3), stud bolts (2), and the fasteners.
Remove clips (4) and (5). Position the harness assembly out of the way.
Remove engine oil pan (1). Remove and discard the isolation seal.
Illustration 2 g02859778
Remove bolts (7) and (8). Remove suction bell assembly (6) .
Illustration 3 g02859838
Remove switch assembly (9) .
Remove plugs (10) and (11) .Installation Procedure
Install engine oil pan (1) in the reverse order of removal.
Illustration 4 g02466177
Note: Ensure that the oil pan and mating surfaces are clean and free of oil.
Apply Tooling (A) at four locations marked (A). Tooling (A) should be applied in 4 1 mm (0.16 0.04 inch) diameter beads.Note: All joints using Tooling (A) must be assembled within 10 minutes of the application.
Tighten plugs (11) to a torque of 90 15 N m (66 11 lb ft).
Tighten plugs (10) to a torque of 70 15 N m (52 11 lb ft).
Illustration 5 g02466597
Torque Sequence
Tighten bolts (3) and stud bolts (2) in the above sequence.