PUMP GP-PS-V-B 10R7402 - Caterpillar

(28)Winch Breather
1. Remove and discard breather. Install a new breather.(29)Winch Oil Sump
Hot oil or components can cause personal injury if they contact skin. Use caution when draining oil or changing filters.
Park machine, on level ground, lower equipment, apply parking brake and shut engine off. 1. Remove drain plug and fill plug. Allow oil to drain.2. Clean and install drain plug. 3. Remove strainer cover. Remove the strainer.4. Wash the strainer in clean non-flammable solvent.5. Install strainer and strainer cover.6. Fill compartment until oil is visible in the sight gauge. See REFILL CAPACITIES. Clean and install fill plug.7. Start and run engine at low idle. Observe oil level with engine running at low idle. Oil level must be visible in sight gauge.(30)Universal Joint And Clutch Brake (Direct Drive)
1. Remove floor plate. Lubricate 2 fittings for the universal joints. 2. Lubricate 1 fitting for the flywheel clutch brake assembly Total 3 fittings.3. Install floor plate.(31)(30)Final Drives
Hot oil or components can cause personal injury if they contact skin. Use caution when draining oil or changing filters.
Park machine on level ground, equipment lowered, parking brake applied and engine OFF. 1. Remove final drive fill plug on each side. 2. Remove drain plug on each side and allow oil to drain.3. Clean and inltall drain plugs.4. Fill compartments with oil. See REFILL CAPACITIES.5. Clean and install fill plugs.(32)Transmission And Torque Converter (Power Shift)
Hot oil or components can cause personal injury if they contact skin. Use caution when draining oil or changing filters.
Park machine on level ground, equipment lowered parking brake applied and engine OFF. 1. Remove transmission drain plug and allow oil to drain. 2. Remove cover housing spring and screen. 3. Remove nut on stud and separate cover, housing, spring and screen. Wash screen in clean solvent. 4. Inspect cover gasket. Install new cover gasket if necessary. 5. Install screen, spring and housing to cover. Be sure pin on screen is aligned with hole in cover. Install nut on stud.6. Install screen assembly.7. Install transmission and torque converter drain plug. 8. Remove breather and install new breather.9. Open right side access door.10. Remove fill plug.11. Fill compartment with oil. See REFILL CAPACITIES.12. Observe oil level with engine running at low idle and transmission in NEUTRAL.13. Add oil if necessary. Install fill plug.(33)Bevel Gear, Steering Clutch Compartment And Steering Booster System (Direct Drive & Power Shift)
Hot oil or components can cause personal injury if they contact skin. Use caution when draining oil or changing filters.
Park machine on level ground, lower all equipment, engage parking brake, and shut engine OFF. 1. Remove 3 drain plugs from the bevel gear and steering clutch compartment. Allow oil to drain.2. Clean and install drain plugs. 3. Remove breather. Install a new breather. 4. Open access door. Fill compartment with oil. See REFILL CAPACITIES.5. Measure oil level, add oil if necessary.(34)Flywheel Clutch Breather
Remove and discard breather. Install a new breather.