PUMP GP-GEAR 1112054 - Caterpillar

(1) Put 9S3265 Thread Lock on the threads of 20 bolts and tighten to a torque of ... 120 to 135 N m (90 to 100 lb ft)(2) Put 9S3265 Thread Lock on the threads of 14 bolts and tighten to a torque of ... 80 to 90 N m (60 to 65 lb ft)(3) Torque for wheel bearing nut ... 680 N m (500 lb ft) While rotating the wheel, strike the rim and surrounding parts with a mallet to seat bearing. Reverse the adjusting nut and strike again. Loosen adjusting nut until there is light bearing end play. After assembly of new bearings, loosen nut to relieve preload to zero torque. Tighten nut. Check rolling torque. Torque for rotation of wheel hub ... 10 to 17 N m (7 to 12 lb ft). After assembly of old bearings, loosen nut to relieve preload to zero torque. Tighten nut. Check rolling torque. Torque for rotation of wheel hub ... 4 to 7 N m (3 to 5 lb ft).(4) Put 9S3265 Thread Lock on the threads of 12 bolts and tighten to a torque of ... 55 to 60 N m (40 to 45 lb ft)(5) Put 9S3265 Thread Lock on the threads of 10 nuts and tighten to a torque of ... 120 to 135 N m (90 to 100 lb ft)(6) Put 9S3265 Thread Lock on the threads of 28 bolts and tighten to a torque of ... 410 to 447 N m (300 to 330 lb ft)(7) Put 9S3265 Thread Lock on the threads of four bolts and tighten to a torque of ... 90 to 95 N m (65 to 70 lb ft)Differential
(8) Differential assembly backlash ... 23 to 33 mm (.009 to .013 in)(9) No-spin differential Length under test force ... 21.8 mm (.86 in)Test force ... 290 31 N (65 7 lb)(10) Standard differential(11) Torque for four bolts ... 295 to 325 N m (220 to 245 lb ft)(12) Torque for bolts ... 35 to 39 N m (25 to 28 lb ft)(13) Torque for 12 bolts ... 120 to 135 N m (90 to 100 lb ft)(14) Torque for 12 bolts ... 120 to 135 N m (90 to 100 lb ft)(15) Torque for locknut ... 370 N m (275 lb ft)(16) Screw adjustment ... .025 to .038 mm (.010 to .015 in) Apply 5P3410 Pipe Sealant to thrust screw threads.(17) Torque for nine bolts ... 120 to 135 N m (90 to 100 lb ft)(18) Torque for 9/16 in. bolt ... 170 to 190 N m (125 to 140 lb ft)(18) Torque for five 1/2 in. bolts ... 120 to 135 N m (90 to 135 lb ft)(19) Torque for nut ... 647 to 705 N m (480 to 520 lb ft)(20) Bearing preload ... 1 to 3 N m (9 to 27 lb in) Add or remove shims to adjust preload. Refer to KENR1314 CS-551 Vibratory Compactor Vehicle