PUMP GP- 1159599 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     1U-7519     Hydraulic Pump     1    
6V-7047 Single Acting Cylinder     1    
FT-3039 Receiving Sleeve     1    
FT-3038 Puller Plate     1    
5P-4776 Tool Stud     1    
9U-6833 Nut     1    Start By:
Remove the bucket. Refer to, "Bucket - Remove".
Illustration 1 g01232760
Position stick (1) onto suitable cribbing. Release the hydraulic system pressure. Refer to Disassembly and Assembly, "System Pressure - Release".
Illustration 2 g01232761
Remove nut (2) and bolt (3). Remove pin (4). Remove any shims that may be present.
Illustration 3 g01232765
Remove nuts (7) and bolt (5). Remove right side link (6). Remove any shims that may be present.
Illustration 4 g01232767
Remove pin (9). Remove link and bearing assembly (10). Remove left side link (8) .
Illustration 5 g01232794
Use Tooling (A) in order to remove bearings (11) and (12) from link and bearing assembly (10) .Installation Procedure
Table 2
Required Tools    
Tool    Part Number    Part Description    Qty    
B     1P-0510     Driver Gp     1    
Illustration 6 g01232798
Lower the temperature of bearings (11) and (12). Use Tooling (B) in order to install bearings (11) and (12) .
Illustration 7 g01232767
Position link and bearing assembly (10). Install left side link (8) and pin (9) .
Illustration 8 g01232765
Install any shims that were present during the removal procedure. Install right side link (6). Install bolt (5) and nuts (7) .
Illustration 9 g01232761
Install any shims that were present during the removal procedure. Install pin (4). Install bolt (3) and nuts (2) .
Illustration 10 g01232760
Remove stick (1) from the suitable cribbing.End By: Install the bucket. Refer to , "Bucket - Install".