PUMP GP-FUEL TFR & PRIMING 1179186 - Caterpillar

Personal injury or death can result from a fire.Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire.Clean up all leaked or spilled fuel. Do not smoke while working on the fuel system.Turn the disconnect switch OFF or disconnect the battery when changing fuel filters.
Do not fill fuel filters with fuel before installing them. Contaminated fuel will cause accelerated wear to fuel system parts.
Illustration 1 g00751855
(1) Drain hose (2) Drain valve (3) Fuel filter (4) Fuel filterNote: Refer to Operation and Maintenance Manual, "General Hazard Information" for information on containing fluid spillage.
Position a suitable container for the used fluid under drain hose (1) .
Unlatch the engine hood and raise the engine hood.
Open two drain valves (2). Allow the fuel in the filters (3) and (4) to drain into the container.
Securely tighten two valves.Note: Dispose of used filters according to local regulations.
Remove fuel filters (3) and (4) .
Inspect the fuel filter for debris by cutting the fuel filter open.Note: This fuel filter is a cartridge type filter. This type of filter cannot be reused.
Clean the mounting base of the fuel filter. Make sure that all of the old seal is removed from the mounting base.
Illustration 2 g00101318
Apply a thin coat of clean diesel fuel to the sealing surface of the new fuel filter.
Install the new fuel filter by hand. When the seal contacts the filter mounting base, tighten the filter by an additional 3/4 turn.The filter has rotation index marks that are spaced by increments of 1/4 turn. Use these rotation index marks as a guide for proper tightening.
Prime the fuel system. See Operation and Maintenance Manual, "Fuel System - Prime" for instructions.
Close the engine hood and latch the engine hood.