PUMP GP-WATER 1189727 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     1U-7498     Support Stand As     4    
B     1U-9745     Air/Hydraulic Jack Gp     1    
C     1P-0520     Driver Gp     1    
Illustration 1 g03105603
Use Tooling (C) to install bushing (13) and seal (12). Repeat this step for the other side.Note: Do not apply any lubricant to the inside diameter of seal (12) or bushing (13) .
Illustration 2 g03105596
Attach a suitable lifting device to both sides of front drive and steering axle (7). The weight of front drive and steering axle (7) is approximately 408 kg (900 lb). Use the suitable lifting device to position front drive and steering axle (7) to the machine.
Illustration 3 g03105599
Illustration 4 g03094997
Position washers (9) and (10) and thrust washers (8) and (11) to both sides of front drive and steering axle (7). Install pin assembly (5) .Note: Use the required number of washers (10) on the front side of front drive and steering axle (7) in order to maintain a gap of 0.8 mm (0.03 inch) maximum.Note: Do not apply any lubricant to pin assembly (5). Note: The flange of pin assembly (5) must be rotated downward before installation in order to clear the frame.
Install bolt (6) .
Illustration 5 g03096256
Connect drive shaft (4) .
Illustration 6 g03096237
Illustration 7 g03096238
Connect hose assemblies (2) and (3) .
Install the counterweight.
Install the front tires and rims.
Illustration 8 g03094942
Use Tooling (B) to remove Tooling (A) from the front of the machine.
Illustration 9 g03094858
Use Tooling (B) in order to remove Tooling (A) from the rear of the machine.
Illustration 10 g02901639
Remove lift cylinder brace (1) and lower the bucket.