PUMP GP-GOV & FUEL INJ 1193842 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1U-9745 Air/Hydraulic Jack Gp 1
B 180-3034 Repair Stand Set 2
Illustration 1 g01153165
Loosen lug nuts (3). Do not remove lug nuts (3) at this time.
Illustration 2 g01153151
Use Tooling (A) in order to raise the rear of the machine. Position Tooling (B) under the rear axle. Lower the machine onto Tooling (B).
Illustration 3 g01153155
Remove bolts (1) from fender (2).
Illustration 4 g01153167
Remove filter (5). Remove bolt (4) and remove fender (2).
Illustration 5 g01153201
Attach a suitable lifting device to the rear tire and rim (6). The weight of the rear tire and rim (6) is approximately 113 kg (250 lb). Remove lug nuts (3) and remove the rear tire and rim (6). Installation Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
A 1U-9745 Air/Hydraulic Jack Gp 1
B 180-3034 Repair Stand Set 2
Illustration 6 g01153201
Attach a suitable lifting device to the rear tire and rim (6). The weight of the rear tire and rim (6) is approximately 113 kg (250 lb). Apply a drop of oil on lug nuts (3). Install the rear tire and rim (6) and install lug nuts (3). Do not tighten lug nuts (3) at this time.
Illustration 7 g01153165
Remove Tooling (B). Lower the machine onto the ground. Tighten lug nuts (3) to a torque of 190 40 N m (140 30 lb ft). Then, turn lug nuts (3) by an additional 60° 5°.
Illustration 8 g01153167
Install fender (2) and install bolt (4). Install filter (5).
Illustration 9 g01153155
Install bolts (1) to fender (2).