PUMP GP-AUXILIARY SEA WATER 1240461 - Caterpillar

Table 2
Required Tools    
Tool     Part Number     Part Description     Qty    
A     127-4904     Repair Stand     1    
B     195-4609     Seal Pick     1    
C     5P-0960     Molybdenum Grease        
Cylinders equipped with lock valves can remain pressurized for very long periods of time, even with the hoses removed.Failure to relieve pressure before removing a lock valve or disassembling a cylinder can result in personal injury or death.Ensure all pressure is relieved before removing a lock valve or disassembling a cylinder.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 4 g01031459
(1) Torque for the head ... 265 15 N m (195 11 lb ft) (2) Torque for the setscrew ... 22 2 N m (16 1 lb ft) (3) Torque for the nut ... 485 15 N m (358 11 lb ft)Note: Lubricate seals and sealing lips with Tooling (C) before assembly.Installation Procedure
Table 3
Required Tools    
Tool     Part Number     Part Description     Qty    
A     1P-1860     Retaining Ring Pliers     1    
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 5 g00891205
Install cylinder assembly (10) .
Illustration 6 g00891204
The lift arm brace does not exist on the other side of the machine.
Install the lift arm brace (7). Install pin (9). Use Tooling (A) to install retaining ring (8). Raise the lift arm brace (7). Install pin (6) .
Illustration 7 g00891294
Position spacer (11) to the inside of the machine. Install pin assembly (1) .
Illustration 8 g00891203
Install bolt (2). Connect tube assemblies (4) and (3). Tighten clamp (5) .
Repeat Steps 1 through 4 for the other