PUMP GP-PISTON 1243761 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 8S-7611 Tube Assembly 2
8S-7615 Pin 2
8S-7640 Stand 2
B 183-4797 Track Roller Lifting Fork 1 Note: There is a track guide on each side of the machine. The procedure which follows is for the installation of the track roller with the track guide.
Make sure that all the mounting surfaces on the following components are clean and free of debris before the following components are installed:
Track Roller
Track Guide
Rock Guards
Frame Rail
Illustration 1 g00664675Note: Make sure that the fill/drain plug in the track roller is facing toward the outside of the undercarriage.
Use a suitable lifting device and Tooling (B) in order to put track roller (3) in position on the undercarriage. The weight of the track roller is approximately 40 kg (88 lb).
Install the bolts that hold the track roller in position.
Illustration 2 g00664663
Use Tooling (B) in order to put track guide (2) in position on the undercarriage. Install the bolts that secure the guide.
Illustration 3 g00664665
(X) Rock guard
Install the rock guards, if equipped.
Prior to lowering the machine to the ground and tightening the track, make sure that all of the track rollers rotate smoothly by manually turning the track rollers.
Illustration 4 g00489826
Lift the machine off Tooling (A).
Remove Tooling (A) from the machine. Lower the machine to the floor.
Tighten the tension of the track. Refer to Operation and Maintenance Manual, "Track Adjustment - Adjust".