PUMP GP-PISTON 1289062 - Caterpillar

The 368-0005 C-Frame Assembly is used with adapters to lift and lower engines into position during disassembly and assembly.Operation Section
Refer to Working Load Limit (WLL) stamp on tool for lifting capabilities.
Refer to appropriate D & A Service Manual for mounting and lifting hardware and correct location of lifting point.Attaching Link Bracket
Note: Use C-Frame only with approved attachments.
Illustration 4 g02492659
189-0408 Screw Pin Shackle is recommended. Refer to NEHS0960 Tool Operating Manual for additional information on the use of shackles.Note: The following drawings are for illustration purposes only and show the 306-3351 C-Frame Assembly (Lifting). For more information on the 306-3351 C-Frame Assembly , refer to NEHS1019 Tool Operating Manual. Refer to the Nomenclature section of this manual for drawing of the 368-0005 C-Frame Assembly .
Illustration 5 g02495599
Correct Operation
Illustration 6 g02496200
Incorrect OperationRefer to NEHS0961, NEHS0976, and NEHS0980.
Illustration 7 g02496436
Note: Two shackles and a sling may be used to help stabilize the C-Frame assembly during operation.Maintenance Section
Inspection
Inspect Equipment - Inspect tool prior to each use for nicks, burrs, dents, cracks, bent, or worn parts. If damage is found, discontinue use, destroy the tool, and dispose of as scrap.
Working Load Limit (WLL) mark - Do not use lifting device unless load identification (WLL) markings are legible.
Illustration 8 g02496676
Safety Alert - Do not exceed working load limit (WLL) 340.2 kg (750 lbs) for any component being lifted. Overhead lifting device, shackles, and hoist must have adequate weight rating. Failure to follow any of the safety recommendations can result in serious injury or even death.
Illustration 9 g02496697
Safety Alert - Do not use lifting device if mounting hole or lifting holes are elongated or deformed.
Illustration 10 g02517361
Safety Alert - Do not use if C-Frame is bent. Cleaning
Clean the tool using nonsolvent based cleaners.Storage
Store tool indoors in a dry location to prevent rust and corrosion.
Safety Alert - The lifting bracket weighs approximately 23.9 kg (52.7 lbs). Store properly to prevent falling, which can cause personal injury or death. Lay lifting device flat on the ground or support from appropriate hooks. Disposal
At the end of the tool's operational life, destroy the tool and dispose of as scrap.