PUMP & MTG GP-HYDRAULIC 1337337 - Caterpillar

new parts.
Illustration 15 g00453558
Remove two bolts (40) and block (41) .
Illustration 16 g00453559
Remove the bolt that holds collar (42) to bolt (44). Remove collar (42), spring (43) and bolt (44) .
Remove the stop screws from collar (42) if the collar needs to be replaced.
Illustration 17 g00453560
Remove three bolts (46) and remove governor servo (45). The governor servo must be rotated in order to be released from the rack's regulator.
Illustration 18 g00453632
Remove lockring (50), seat (53), link spring (52) and sleeve (51). Remove the other lockring (50) from the groove in the center of valve (47). Remove valve (47), sleeve (48) and piston (49). The piston must be pushed down in order to be removed. Remove the O-ring seal from sleeve (48). Remove pin (55) and lever (56) .
Illustration 19 g00453633
Illustration 20 g00453634
Use Tool (A) in order to hold spring (58) compressed for the removal of ring (57). Spring (58) is used in order to put a preload on the thrust bearing for the camshaft in the fuel injection pump housing.
Remove ring (57) and slowly release Tool (A) .
Illustration 21 g00453635
Remove bearing (60), sleeves (59) and spring (58) .
Illustration 22 g00453636
Remove ring (61) and dashpot assembly (62) .
Illustration 23 g00453637
Use Tool (C) in order to remove snap ring (68). Remove ring (67) and spool (66) .
Remove seat (65) from spring (64) and remove spring (64) from seat (63) .
Illustration 24 g00453665
Remove riser (69) .
Illustration 25 g00453667
Remove ring (70), races (71) and bearing (72) .
Illustration 26 g00453668
Remove four bolts (73) and carrier (74) .
Illustration 27 g00453669
Remove dowels (77) and flyweights (76). Remove governor shaft (75) and the dowel that is not shown from shaft (75) .
Illustration 28 g00453670
Remove races (78) and bearing (79) .