PUMP GP-PISTON 1411462 - Caterpillar

Removal Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Disconnect all electrical connections to the fuel shutoff solenoid before proceeding. Mark all connections for later installation.
Illustration 1 g00592462
Remove fuel shutoff solenoid (1) from the governor by rotating fuel shutoff solenoid (1) in a counterclockwise direction.
Remove the O-ring seal from fuel shutoff solenoid (1). Inspect the O-ring seal for wear or for damage. If the O-ring seal is worn or damaged, use a new part for replacement.Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 2 g00592462
Install the O-ring seal onto fuel shutoff solenoid (1) .
Install fuel shutoff solenoid (1) in the governor by rotating fuel shutoff solenoid (1) in a clockwise direction. Tighten fuel shutoff solenoid (1) to a torque of 17 N m (12 lb ft).Note: Reconnect all electrical connections to the fuel shutoff solenoid before you operate the engine.