PUMP GP-GEAR 1425000 - Caterpillar

Illustration 12 g03714958
Touch "Material Paddle Sensor" (16).
Illustration 13 g03714962
Touch "Right Conveyor Sensor" (17).
Illustration 14 g03715319
Read the on-screen warnings (18), touch "OK" icon (19).
Illustration 15 g03715322
Touch "OK" icon (19) to begin calibration.
Illustration 16 g03715325
Follow setup instructions (20).
Illustration 17 g03715332
Shut off the engine. Press and hold push to start switch (21) for 3 seconds. An LED next to the push to start switch will flash when the engine is in shutdown mode. Note: The engine may run for several minutes when placed in the shutdown mode.
Illustration 18 g03715337
When setup instructions are met, touch "NEXT" icon (22).
Illustration 19 g03715345
Follow calibration instructions (23).
Illustration 20 g03715355
Lift right paddle (24) to a 45 degree angle in order to place the paddle sensor in the full OFF position.
Illustration 21 g03715364
Touch "NEXT "icon (22).
Illustration 22 g03715366
Follow calibration instructions (25).
Lower right paddle (24) to the straight down position in order to place the paddle sensor in the full ON position.
Illustration 23 g03715364
Touch "NEXT "icon (22).
Illustration 24 g03715377
The display should now read "Calibration Successful" (26). Touch "OK" icon (19).
Repeat Step 10 through Step 18 to calibrate the left material feed paddle sensor.
Illustration 25 g03715386
Touch "HOME" icon (27) to exit the calibration screen.
Press the up arrow on auger height switch (7). Raise the augers. Note: In order to avoid possible damage to the flighting, the augers should be raised before moving the machine.
Illustration 26 g03715393
Move machine power switch (28) to the OFF position.