PUMP GP-MTG 1461530 - Caterpillar

Illustration 1 g00130641
Set the blade in order to deliver material outside the left rear wheels.
Illustration 2 g00130642
Set the blade horizontally at the desired depth of the cut. Lean the wheels to the left in order to overcome the side draft.
Illustration 3 g00123358
Tip the blade to the best position for the material that is being graded. Start with the top of the moldboard approximately 100 mm (4 inches) ahead of the cutting edge.
Under good conditions, grade the material from one side to the other side.
Spread the loose material over the surface until the surface is smooth.Normally, the machine is used with the frame straight for flat grading. Articulate the machine in order to counteract the draft from blades that have heavy loads on the side. Turn the front of the tandem wheels toward the heel of the moldboard.If the wheels start to spin, turn the front of the tandem wheels away from the heel. This will reduce the width of the cut. This will reduce the load on the machine.In normal leveling work, deliver the material to the outside of the rear wheels. This will maintain a smooth surface for the rear wheels.