PUMP GP-FUEL PRIMING 1516342 - Caterpillar

Number of Switch Inputs
This configuration parameter is the total number of switches that are used. The switches can be individual switches or a multiple rotary switch.
Table 1
Range Default
0 to 2 0 Mode Selection Number
This parameter is a non-programmable parameter that represents the number of possible combinations of switch positions. This parameter is based on the value that is programmed into the "Number of Switch Inputs" parameter.Mode Selection Switch Input 2 and Mode Selection Switch Input 1
The number of these non-programmable parameters that are visible depends on the value that is programmed into the "Number of Switch Inputs" parameter. "Open" signifies that the switch is in the OFF position. "Ground" signifies that the switch is in the ON position.Rating Enabled
If "Yes" is selected on the drop-down menu, the ECM is programmed to use the values in the "Rating Number", "Throttle 1 Droop Percentage", "Throttle 2 Droop Percentage" and "TSC1 Droop Percentage" for the given combination of switch positions.
Table 2
Values Default Factory Password
Yes
No No No High Idle Speed
The "High Idle Speed" is the maximum engine rpm.
Table 3
Minimum Maximum Default
1800 rpm 2800 rpm 2420 rpm Rating Number
This parameter is the engine rating that is used by the Electronic Control Module (ECM) for a given combination of switch positions. There is a maximum of four ratings in a flash file.
Table 4
Range Default Factory Password
1 to the maximum number of ratings in the currently installed Flash File 1 No Rated Speed (RPM)
This parameter represents the engine speed that is selected when the mode switch or the mode switches are in a particular position.
Table 5
Range Default Factory Password
"Programmed Low Idle" to "Programmed High Idle" 2100 rpm No Engine High Idle Speed (RPM)
This parameter represents a maximum of 112% of the rated speed that is selected when the mode switch or the mode switches are in a particular position.
Table 6
Range Default Factory Password
"1800 to 2800 rpm" 112% of rated speed No Governor Type
This parameter represents the mode of operation of the governor that is installed on the engine.
Table 7
Range Default Factory Password
"Min/Max speed (rpm)" or "All Speed" All Speed No Throttle 1 Droop Percentage
This parameter represents the amount of droop that is applied to the "Throttle 1" input.
Table 8
Range Default Factory Password
0 to 10 percent 5.0% No Throttle 2 Droop Percentage
This parameter represents the amount of droop that is applied to the "Throttle 2" input.
Table 9
Range Default Factory Password
0 to 10 percent 5.0% No TSC1 Droop Percentage
This parameter represents the amount of droop that is applied to the "Torque Speed Control 1(TSC1)" input.
Table 10
Range Default Factory Password
0 to 10 percent 5.0% No