PUMP GP-2PL-A- 1519736 - Caterpillar

Removal Procedure
Start By:
Remove both the fuel tanks. Refer to Disassembly and Assembly, "Fuel Tank - Remove".
Remove the hood. Refer to Disassembly and Assembly, "Hood - Remove".Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Drain the coolant from the cooling system into a suitable container for storage or disposal. The capacity of the cooling system is 38 L (10 US gal). Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change" for the correct procedure.
Drain the air tanks. Refer to Operation and Maintenance Manual, "Air Tanks Moisture and Sediment - Drain" for the correct procedure.
Illustration 1 g00990885
Disconnect tubes (1). Remove clamps (2). Position tubes (1) out of the way.
Illustration 2 g00990921
Remove bolts (3). Disconnect harness assemblies (4). Disconnect ground cable (5). Disconnect cable assembly (6) .
Illustration 3 g00920663
Disconnect harness assemblies (7) .
Illustration 4 g00920664
Disconnect hose assemblies (8) .
Illustration 5 g00920666
Disconnect fitting (9). Remove the hose assemblies from clips (10) .
Illustration 6 g00990889
Disconnect hose assembly (11). Disconnect hose assemblies (12) .
Illustration 7 g00990891
Attach a suitable lifting device to support (13). The weight of support (13) is approximately 340 kg (750 lb).
Illustration 8 g00990892
Illustration 9 g00990894
Remove bolts (15). Remove clamp (14). Remove clamp (16) .
Remove support (13). The weight of support (13) is approximately 340 kg (750 lb).