PUMP GP-PISTON 1599454 - Caterpillar

Dash Display Access Parameters
The parameters Change Fuel Correction Factor, PM1 Reset, and Fleet Trip Reset establish security access for the Caterpillar Driver Information Display. These parameters require a Caterpillar Driver Information Display for access.State Selection
Program to NO to disable this function of the Cat ID. The Cat ID will not show state selection as an option to the driver. If programmed to Yes (default) the Cat ID will provide the State Selection feature.Programming this parameter to NO eliminates state crossing selection and therefore storage of State tagged trip data. This parameter requires AUG96 or later Personality Modules. Change Fuel Correction Factor
Allows the driver to adjust the Fuel Correction Factor. An owner-operator would want driver access to this information, but a fleet operation might not. This parameter is available in APR94 or later Personality Modules. PM1 Reset
Determines access for the driver to reset the PM1 Maintenance, when performed. Maintenance Indicator Mode cannot be programmed to OFF for the PM1 Reset parameter to take effect. Fleet Trip Reset
Fleet Trip Reset sets access for the driver to reset the Fleet Trip Information. This parameter is available in APR94 or later Personality Modules. Theft Deterrent System Control
When used with a Theft Deterrent Password prevents the engine from starting unless the password has been entered via the CAT ID dash display. The operator must first enter the password before the engine shuts off in order to enable the system, preventing engine starting without reentering the password on the next attempted start. This parameter is available in JAN95 or later Personality Modules. Theft Deterrent Password
The password required by the ECM before the Theft Deterrent feature is enabled or prevents engine starting. This parameter is available in JAN95 or later Personality Modules. Quick Stop Rate
Determines the rate of vehicle speed change the ECM uses to record a Quick Stop Event Code and Quick Stop Snapshot. Programmable from 0-15 mph/s (0-24 km/h/s, 0 = default = OFF). Each Quick Stop Snapshot contains 60 frames of information; frame 45 is the Quick Stop occurrence, 44 frames before, 15 frames following the code. Each frame is separated by 1.0 second. This parameter is available in