PUMP GP-ENGINE OIL 1614110 - Caterpillar

Remove Automatic Timing Advance (Earlier)
1. Set the fuel injection pump timing. See REMOVE FUEL INJECTION PUMP HOUSING AND GOVERNOR for timing procedure. Tools (A) and (B) will be needed to set the timing.
INDUSTRIAL ENGINE2. Remove nuts (1). Remove cover (2) from the timing gear cover.
MARINE ENGINE3. Loosen bolt (3). Hit the bolt with a soft hammer until the automatic timing advance is loose.4. Remove bolt (3) and washer (4). Remove automatic timing advance (5).Install Automatic Timing Advance (Earlier)
MARINE ENGINE1. Put automatic timing advance (1) in position on the drive shaft for the fuel injection pump.
INDUSTRIAL ENGINE2. Install washer (2) and bolt (3). Tighten bolt (3) to a torque of 15 lb.ft. (20 N m). Remove tool (A) from the fuel injection pump housing. Tighten bolt (3) to a torque of 110 10 lb.ft. (149 14 N m).
Do not tighten the bolt to final torque unless tool (A) is removed.
3. Put the cover in position on the timing gear cover. Install the nuts that hold it.4. Remove tool (A) from the fuel injection pump housing. Install the plug in the fuel injection pump housing. Remove the timing bolt from the flywheel.