PUMP GP-ENGINE OIL 1614112 - Caterpillar

Before performing this procedure, inspect the harness connectors that are involved in the circuit. Poor connections can often be the cause of a problem in an electrical circuit. Verify that all connections in the circuit are clean, secure and in good condition. If a problem with a connection is found, correct the problem and verify that this diagnostic code is active before performing this procedure.
Possible Causes for an FMI 3 Diagnostic code are:
The return circuit is open.
The signal circuit is open or the sensor is disconnected.
The signal circuit is shorted to the +battery.
The sensor has failed.
The ECM has failed. This condition is unlikely.
Possible Causes for an FMI 4 Diagnostic code are:
The sensor has failed
The signal circuit for the sensor is shorted to ground
The ECM has failed. A failure of the Transmission ECM is unlikely.
Illustration 1 g03376641
Schematic of the J1 Temperature and Speed Passive/Analog SensorsThe table below is a reference that can be used when checking the resistance of the temperature sensors listed in the table above.
Table 2
CELSIUS TEMPERATURE     FAHRENHEIT TEMPERATURE     RESISTANCE    
10     50     1991.4    
15     59     1571.9    
20     68     1249.5    
25     77     1000    
30     86     805.5    Note: The diagram above is a simplified schematics of the Transmission ECM connections. The schematic is electrically correct. However, not all of the possible harness connectors are shown. Refer to the latest revision of Electrical Schematic, UENR1687 for the complete schematic of 966H and 972H Wheel Loaders Electrical System. Refer to the latest revision of Electrical Schematic, UENR1699 for the complete schematic of 980H Wheel Loaders Electrical System.
Table 3
Troubleshooting Test Steps    Values    Results    
1. Identify The Active DTC Code Associated With The Suspect Circuit    
Code present.     FMI 3 diagnostic code, proceed to Test Step 2.
FMI 4 diagnostic code, proceed to Test Step 5.    
Begin Process For FMI 3 Troubleshooting HERE    
2. Check The Sensor
Note: See Table 2 for a list of resistances related to specific temperature values. The maximum resistance for the sensor is 33,650 Ω, the minimum is 51.2 Ω.
A. Turn the key start switch and the disconnect switch to the OFF position.
B. Disconnect the sensor from the harness.
C. Measure the resistance between pin 1 and 2 of the sensor.    
The resistance reading agrees with the values from Table 2.     OK - The resistance reading agrees with the values in 2.
Proceed to Test Step 3.
NOT OK - The resistance reading does not agree with the values in 2.
Repair: Replace the sensor.
STOP    
3. Check For An Open In The Sensor Circuit
A. The key start switch and disconnect switch remain in the OFF position.
B. The harness connector remains disconnected from the sensor.
C. Disconnect the J1 and J2 connectors from the ECM.
D. At the harness connector for the sensor install a jumper wire.
E. At the harness connector for the ECM measure the resistance at the contacts for the sensor.    
The resistance reading is less than 5