PUMP GP-PISTON 1623140 - Caterpillar

Introduction
THIS SPECIAL INSTRUCTION IS A SUPPLEMENT TO THE MACHINE'S OPERATION AND MAINTENANCE MANUAL. THIS DOCUMENT MUST BE PERMANENTLY ATTACHED TO THE MACHINE'S OPERATION AND MAINTENANCE MANUAL. This Special Instruction provides information on the operation of the Machine Security System.Safety Section
Operation of the machine and maintenance of the machine must not occur unless the instructions and warnings in the machine's Operation and Maintenance Manual have been read and the instructions and warnings are understood. The contents of this Special Instruction must also be understood before operating a machine that is equipped with the Caterpillar Machine Security System.
DO NOT OPERATE OR WORK ON THIS MACHINE UNLESS YOU HAVE READ AND UNDERSTAND THE INSTRUCTIONS AND S IN THE OPERATION AND MAINTENANCE MANUALS. FAILURE TO FOLLOW THE INSTRUCTIONS OR HEED THE S COULD RESULT IN INJURY OR DEATH. CONTACT ANY CATERPILLAR DEALER FOR REPLACEMENT MANUALS. PROPER CARE IS YOUR RESPONSIBILITY.
Operation Section
This machine is equipped with a Caterpillar Machine Security System (MSS) and may not start under certain conditions. Read the following information and know your machine's settings. Your Caterpillar Dealer can identify your machine settings.
Machine Security System (MSS) - Machines that are equipped with a Caterpillar Machine Security System (MSS) can be identified by a decal in the operator station. THE MSS is designed to be a theft deterrent or the MSS will prevent the unauthorized operation of the machine. Basic Operation
MSS may be programmed to use a standard Caterpillar key or an electronic key. The electronic key contains an electronic chip within the plastic housing for the key. Each key emits a unique signal to the MSS. The keys can be identified by a gray housing or a yellow housing. MSS may have programmed settings that require an electronic key for starting during certain periods of time. The MSS may also have programmed settings that allow a standard Caterpillar key to start the machine during certain periods of time.Note: Ensure that you have only one electronic key near the exciter coil when you are attempting to start the machine. If there is more than one electronic key near the exciter coil the MSS may not be able to read the key in the keyswitch and the machine will not start.When the key start switch of the machine is turned to the ON position, the ECM will read the unique ID that is stored in the electronic key. The ECM will then compare this ID to the list of authorized keys. The following table tells the operator the status for starting the machine. The status light is located near the key start switch.
Table 1
Green light     The key is authorized.    
Red light     The key is not authorized.    Note: MSS will not shut down the machine after the machine has started. Security Management
The MSS has the capability to allow you to program the system to automatically activate at different time periods with different keys. The MSS can also be programmed to reject a specific electronic key after a selected date