PUMP & MTG GP-MAIN HYDRAULIC 1626176 - Caterpillar

Inspect
Open the access door on the right side of the machine.Note: Even if only one belt is worn or damaged, replace the belts in sets.
Inspect the condition of the fan drive belt and the alternator and water pump belt. The belts should deflect 14 to 20 mm (.56 to .81 inch) under 110 N (25 lb) of force. Use a 144-0235 Belt Tension Gauge in order to measure the tension.Adjust/Replace
Illustration 1 g00850323
Alternator and Water Pump Belt
Loosen bolts (1) .
Turn adjusting nuts (2) until the correct belt tension is reached. To achieve the correct belt adjustment, move the alternator inward or move the alternator outward, as required.
Tighten bolts (1) .
Illustration 2 g00850322
Fan Drive Belt
Loosen bolts (1) .
Turn the adjusting nuts (2) until the correct belt tension is reached. To achieve the correct belt adjustment, move the idler pulley inward or move the idler pulley outward, as required.
Tighten bolts (1) .
Close the access door.Note: Use the same procedure in order to replace the belts.Note: If new belts are installed, check the belt adjustment again after 30 minutes of engine operation.