PUMP GP-GEAR 1655932 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     1U-9745     Jack     1    
B     6V-6146     Load Levelers     1    Start By:
Connect the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".
Release hydraulic system pressure. Refer to Disassembly and Assembly, "Hydraulic System Pressure - Release".
Remove the drive shaft. Refer to Disassembly and Assembly, "Drive Shaft - Remove and Install".
Remove the parking brake for the 908. Refer to Disassembly and Assembly, "Parking Brake - Remove and Install".
Remove the tire and rim. Refer to Disassembly and Assembly, "Tire and Rim - Remove and Install".
Remove the service and parking brake for the 906. Refer to Disassembly and Assembly, "Service and Parking Brake - Remove and Install".
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Personal injury or death can result from improper lifting or blocking.When a hoist or jack is used to lift any part or component, stand clear of the area. Be sure the hoist or jack has the correct capacity to lift a component. Install blocks or stands before performance of any work under a heavy component.Approximate weights of the components are shown. Clean all surfaces where parts are to be installed.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on the lines for installation purposes. Plug the lines. This will help to prevent fluid loss and this helps to keep contaminants from entering the system.
Illustration 1 g00647496
Tooling (B) is located on top of the strap.
Use Tooling (A) to support the front fixed axle. Use Tooling (B) to stabilize the fixed axle.
Illustration 2 g00647504
Remove nuts, washers, plates, and eight bolts (3) from the fixed axle.
Use Tooling (A) and Tooling (B) to lower fixed axle (4). Use Tooling to remove the fixed axle from the front of the machine. Weight of the fixed axle is 379 kg (835 lb).