PUMP GP-ENGINE OIL 1747916 - Caterpillar

Table 1
Service Tools
Part Number Part
Current Version Caterpillar Electronic Technician (Cat-ET)
317-7486 Communication Adapter II Group for use with Cat-ET (1)
317-7484 Communication Adapter 3 Group for use with Cat ET(1)
257-9140 Digital Fluke 87V Multimeter
8T-3224 Needle Tip Group
7X-1710 Multimeter Probe Group
8T-8726 Adapter Cable Assembly, 3-Pin Breakout
208-0059 70 Pin Breakout T Harness
1U-5804 Crimp Tool
8T-5319 CE/VE Connector Tool Group - Circuit Removal Tool
6V-4148 Electrical Connector Repair Kit - Amp connectors
362-3555 Ampseal Connector Kit - Ampseal connectors
6V-3000 Sure Seal Repair Kit - Sure Seal connectors
175-3700 DT Connector Service Kit - Deutsch DT connectors
175-3700 Connector Repair Kit - DT
140-9944 Terminal Repair Kit
190-8900 Connector Repair Kit
9X-1314
9X-1315 Red, Black Pin Probe - For use with a multimeter to insert in a connector socket
309-6081
309-6082 Red, Black Socket Probe - For use with a multimeter to insert on a connector pin
177-2330 Digital Battery Analyzer
4C-4911 Battery Load Tester
276-7273 Sensor Test Box (2)
(1) The Comm II Adapter or the Comm Adapter 3 will both work with Cat-ET .
(2) Instrument used to test Cylinder Position sensors.
Illustration 1 g00774942
Connections for the Communication Adapter II or the Communication Adapter 3 and Cat-ET.
The components that are needed in order to use the Communication Adapter II and Cat-ET to determine diagnostic codes are:
(6) Cable
(7) 275-5120 Communication Adapter II Group or 317-7484 Communication Adapter 3 Group
(8) Service connector diagnostic cable.
(9) Current version of Cat-ET program software and an IBM-COMPATIBLE personal computer Reference: Refer to the Special Publication, NEHS0758, "Communications Adapter II User Manual ".Note: Caterpillar Electronic Technician (ET) is a software program that can be used on an IBM compatible personal computer. In order to use Cat-ET, order the following materials: Special Publication, JERD2124, "ET Single Use Program License", Special Publication, JEHP1026, "Information and Requirements Sheet", 7X-1425 Data Link Cable and the Data Subscription and Special Publication, JERD2142, "Data Subscription". The Special Publication, JEHP1026, "Information and Requirements Sheet" lists the required hardware and the features of the Cat-ET service tool.Cat-ET is not required to determine the diagnostic codes. Cat-ET is also not required to clear diagnostic codes. However, the process of determining the diagnostic codes is easier and faster when using the Cat-ET service tool. Cat-ET can also display information on the history of a diagnostic code and the parameter status of diagnostic codes. These features allow Cat-ET to be a useful tool for troubleshooting.Cat-ET is used to communicate with the electronic control module over the data link circuits when connected to the machine diagnostic service connector. For information on the locations of the machine harness wiring connectors, refer to the complete Machine Electrical System Schematic in your machine Service Manual.For instructions on servicing Sure Seal connectors, see Special Instruction, SMHS7531. For instructions on servicing Deutsch connectors, see Special Instruction, SEHS9615. The 7X-1710 Multimeter Probes are used to measure the voltage at the connectors without disconnecting the connectors. The probe ends are pushed into the back of the connector along the wire.The 151-6320 Removal