PUMP GP-ENGINE OIL 1992233 - Caterpillar

Illustration 1 g01398914
Note: Apply seal (1) to plate (4). The seal should be centered between the fasteners that are on both sides of the console, as shown. (1) Approximate length of the seal ... 500 10 mm (19.7 0.4 inch) (3) Adjust the locking bolt when the console is in the FULL FORWARD position in order to maintain a 20 to 25 mm (0.8 to 1.0 inch) minimum clearance with the instrument panel. (4) 8C-3442 Coil Spring Length under test force ... 57.9 mm (2.28 inch) Test force ... 71.2 5.8 N (16 1.3 lb) Free length after test ... 50.3 mm (1.98 inch) Outside diameter ... 17.48 0.25 mm (0.688 0.010 inch)Note: Apply seal (5) around the opening of cab platform, as shown. (5) Approximate length of the seal ... 400 10 mm (15.7 0.4 inch) (6) Torque for the jam nut ... 25 6 N m (18 4 lb ft) (7) 3Y-2806 Spring Length under test force ... 71.1 mm (2.80 inch) Test force ... 35.50 2.90 N (8.0 0.7 lb) Free length after test ... 48.5 mm (1.91 inch) Outside diameter ... 17.80 mm (0.701 inch) (8) As required, use the bearings to limit the horizontal movement.Note: Center seal (9) between radii, as shown. (9) Approximate length of the seal ... 100 10 mm (3.9 0.4 inch) (E) Rod length beyond lever ... 31 3 mm (1.2 0.1 inch) (F) Depth of bearing in two places ... 3.7 1.5 mm (0.15 0.06 inch) (G) Depth of bearing ... 5.8 mm (0.23 inch)
Illustration 2 g01398913
Section D-D (11) SpacerNote: Thread the cylinder rod (10) into the retainer (12) until the pin (15) contacts the ball (14). Loosen cylinder rod (10) half of a turn. Tighten the nut (13) .Note: Before you install the cylinder rod (9), use 1P-0808 Multipurpose Grease to apply the grease into the cavity of the retainer (12) in order to surround the ball (14).