PUMP GP-SEA WATER 1N8351 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     132-8223     110 volt Power Pack     1    
1U-6221 Torque Wrench     1    
132-8143 36 mm Hex Link     1    
B     138-7574     Link Bracket     4    
C     -     Forcing Bolt
M24 x 3 by 5 inch     2    Start By:
Remove the swing motor. Refer to Disassembly and Assembly, "Swing Motor - Remove".
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Lower the bucket to the ground.
Thoroughly clean the area around the swing drive prior to removal.
Drain the oil from the swing drive. Refer to Operation and Maintenance Manual, "Swing Drive Oil - Change".
Illustration 1 g01206242
Use Tooling (A) to remove bolts (1) that secure the swing drive to the main frame.
Illustration 2 g00875735
Attach Tooling (B) and a suitable lifting device to swing drive (2), as shown. The weight of swing drive (2) is approximately 510 kg (1125 lb).
Illustration 3 g01210665
Remove the two corks from the threaded holes in the swing drive housing. Install Tooling (C) in order to separate the swing drive (2) .
Remove swing drive (2) from the machine. The weight of swing drive (2) is approximately 510 kg (1125 lb). Note: Be careful not to damage pinion gear.