1W5681 PUMP GP-FUEL INJECTION Caterpillar parts
3306
Rating:
Alternative (cross code) number:
CA1W5681
1W-5681
1W5681
CA1W5681
1W-5681
1W5681
Weight: 0.80 pounds 0 kg.
INDUSTRIAL ENGINE,
Compatible equipment models: 1W5681:
Number on catalog scheme:
5
For full view, you need register
Information:
Illustration 1 g01705797
Schematic for the Genset Softstart and Genset Enable SolenoidsThis diagnostic code is associated with the Genset Enable Active Solenoid. The FMI 6 means that the ECM has determined that the current of the solenoid circuit is above normal.The possible causes of the diagnostic code are listed:
The internal windings for the solenoid have low impedance.
The internal windings for the solenoid are shorted.
The signal circuit from the ECM to the solenoid is shorted to ground.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of SPN 5005 FMI 6 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.System Response:The Generator will not start smoothly.Note: Before performing this procedure, verify that all circuit breakers and fuses in the charging circuit and the supply circuit of the ECM system are closed. If a problem with a circuit breaker or a fuse is found, correct the problem and verify that this diagnostic code is active before performing this procedure.Test Step 1. CHECK THE STATUS OF THE DIAGNOSTIC CODE
Turn the disconnect switch and the key start switch to the OFF position.
Inspect the harness connectors. Clean the contacts of the harness connectors and check the wires for damage to the insulation that is caused by excessive heat, corrosion, or chafing.
Perform a 45 N (10 lb) pull test on each of the wires that are associated with the circuit.
Use the Caterpillar Electronic Technician (ET) service tool, if available, in order to perform a "Wiggle Test" on the machine wiring harness. The wiggle test can detect intermittent shorts or opens in the machine wiring harness.
Reconnect all harness connectors. Make sure that the connectors are fully seated and the clips for each connector are completely fastened.
Turn the disconnect switch and the key start switch to the ON position.
Operate the machine.
Determine if the SPN 5005 FMI 6 diagnostic code is still active.Expected Result:The SPN 5005 FMI 6 diagnostic code is still active.Results:
YES - The SPN 5005 FMI 6 diagnostic code remains active.
Caterpillar SIS machinery equipment:
Caterpillar parts catalog:
Parts pump Caterpillar catalog:
215, 215B, 225, 235, 235B, 3304, 3306, 561D, 572G, 627B, 637D, 639D, 963, 973, D5B, D5H, D6D, D7G
3304, 3304B, 3306, 3306B, 515, 525, 615C, 966F, 966F II
235B, 3306, 3306B, 330B L, 350, 627F, 637D, 637E, 639D, 65C, 814F, 815F, 816F, 966F II, 970F, 973, D250E, D300E, D6R, D7R
120G, 12G, 130G, 140G, 14G, 160G, 215D, 219D, 225D, 229D, 235C, 235D, 330, 330 L, 3304, 3304B, 3306, 3306B, 518, 528, 615C, 621E, 627E, 637E, 65, 814B, 815B, 816B, 930R, 936, 936F, 950B/950E, 963, 966...
12H, 12H ES, 12H NA, 140G, 140H, 140H ES, 140H NA, 143H, 14H NA, 160H, 160H ES, 160H NA, 163H NA, 235C, 235D, 330, 330 FM L, 330 L, 3304, 3304B, 3306, 3306B, 330B L, 350, 515, 517, 525, 527, 528B, 530...
1673C, 3304, 3304B, 3306, 3306B, 515, 518, 518C, 525, 528, 528B, 530B, 615, 615C, 621E, 621R, 627B, 627E, 814, 814B, 815, 815B, 816, 816B, 920, 930, 930R, 936, 936F, 950, 950B, 950B/950E, 966C, 966D, ...
330, 3306, 3306B, 3306C, 350, 615C, 966D, 966F, 970F, D250E, D25D, D6H, D6H XL, D6H XR, D6R, D7H, G3306, R1300G
1673C, 3306, 3306B, 3306C, 966F, 972G, G3304, G3304B, G3306, G3306B
3304, 3304B, 3306, 3306B
235, 3306, 615, 627B, 637D, 639D, 814B, 815B, 816B, 936, 950B, 950B/950E, 963, 966D, 973, CS-643
120G, 12G, 12H, 12H ES, 12H NA, 130G, 140G, 140H, 140H ES, 140H NA, 143H, 14G, 14H NA, 160G, 160H, 160H ES, 160H NA, 163H NA, 215D, 219D, 225D, 229D, 235B, 235C, 235D, 330, 330 FM L, 330 L, 3304, 3304...
120B, 140B, 215C, 215D, 219D, 225D, 229, 229D, 235, 235B, 235C, 330, 330 FM L, 330 L, 3304, 3304B, 3306, 3306B, 350, 515, 525, 527, 561D, 571G, 572G, 627B, 627E, 627F, 637D, 637E, 639D, 65, 65C, 70C, ...
1673C, 3306, G3306
