PUMP GP-2PS-D-V 20R1334 - Caterpillar

Instruments
Table 52
Symptom Possible Remedy
Inaccurate generator measurements on controller display Check that the CT primary, CT secondary, and VT ratio settings are correct for the application.
Check that the CTs are wired correctly with regards to the direction of current flow (p1,p2, and s1, s2) and additionally ensure that CTs are connected to the correct phase (errors will occur if CT1 is connected to phase 2).
Remember to consider the power factor (kW = kVA x powerfactor).
The controller is true RMS measuring so gives more accurate display when compared with an ‘averaging’ meter such as an analogue panel meter or some lower specified digital multimeters.
Accuracy of the controller is better than 1% of full scale. Generator voltage full scale is 415V ph-N, accuracy is 4.15V (1% of 415V). Miscellaneous
Table 53
Symptom Possible Remedy
Module appears to "revert" to an earlier configuration When editing a configuration using the PC software, it is vital that the configuration is first "read" from the controller before editing it. This edited configuration must then be “written” back to the controller for the changes to take effect.
When editing a configuration using the fascia editor, be sure to press the Auto Mode button to save the change before moving to another item or exiting the fascia editor Note: The above fault finding is provided as a guide check-list only. As the module can be configured to provide a wide range of different features, always refer to the source of your module configuration if in doubt.Maintenance, Spares, Repair And Servicing
The controller is Fit and Forget. As such, there are no user serviceable parts within the controller. In the case of malfunction, you should contact your original equipment manufacturer (OEM).Purchasing Additional Connector Plugs From DSE
If you require additional plugs from DSE, contact our Sales department using the part numbers below.Pack Of Plugs
Table 54
Module Type Plug Pack Part Number
4510-01 100-400-41
4520-01 100-400-42
4510-02, 4510-03 & 4510-04 100-400-47
4520-02, 4520-03 & 4520-04 100-400-46 Individual Plugs
Table 55
Module Terminal Designation Plug Description Part No
01-Sep DSE4520 Only 9 way 5.08mm 00-7166
01-Jul DSE4510 Only 7 way 5.08mm 00-7155
Oct-20 11 way 5.08mm 00-7451
21-24 4 way 10.16mm 00-7003
25-28 DSE4520 Only 4 way 10.16mm 00-7003
29-32 Not fitted on 45xx-01 4 way 5.08mm 00-7282
PC Configuration interface lead (USB type A – USB type B) 01-6125 Purchasing Additional Fixing Clips From DSE
Module Fixing Clips (Packet Of 2) - Part number - 02-0406
Module Silicon Sealing Gasket - Part number - 02-0282Purchasing Additional Sealing Gasket From DSE
Warranty
DSE provides limited warranty to the equipment purchaser at the point of sale. For full details of any applicable warranty, you are referred to your original equipment supplier (OEM).Disposal
WEEE (Waste Electrical And Electronic Equipment)
Directive 2002/96/ECIf you use electrical and electronic equipment you must store, collect, treat, recycle and dispose of WEEE separately from your other waste.Rohs (Restriction Of Hazardous Substances)
Directive 2002/95/EC: 2006To remove specified hazardous substances (Lead, Mercury, Hexavalent Chromium, Cadmium, PBB & PBDE´s)Exemption Note: Category 9. (Monitoring & Control Instruments) as defined in Annex 1B of the WEEE directive will be exempt