PUMP GP-PS-BSC-V 20R6870 - Caterpillar

General
Accumulated grease and oil on a machine is a fire hazard. Remove this debris with steam cleaning or high pressure water, at least every 1000 hours or each time any significant quantity of oil is spilled on a machine.
Wipe all fittings, caps and plugs before servicing.Keep a close watch for leaks. If leaking is observed, find the source and correct the leak.Check the fluid levels more frequently than the recommended periods if leaking is suspected or observed.Electrical System
When jump starting a machine, follow the instructions in "Engine Starting" in the "Operation Section" to properly start the engine. This machine has a 12 volt starting system. Use only equal voltage for jump starting. The use of a welder or higher voltage will damage the electrical system.
Air Intake System
Check the precleaner screen or bowl daily for accumulation of dust and debris.Remove any dust and debris as needed.If the indicator light comes on shortly after installing a cleaned primary element, install another clean element, or a new element.The primary element can be cleaned up to six times before replacement. The element, when cleaned, should be thoroughly checked for rips or tears in the filter material. Replace the primary element every year, even though it has not been cleaned six times.The secondary filter element should be replaced at the time the primary filter element is serviced for the third time.If the indicator light comes on after installation of a clean primary element, or if the exhaust smoke is black, install a new secondary element.
Do not try to reuse the secondary element by cleaning it. Always use a new element. Engine damage can result.