PUMP GP-2PS-E-V 20R7282 - Caterpillar

Note: The bolts are three different lengths. Note the positions of the different bolts.
Illustration 5 g06271512
Illustration 6 g06271514Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 6V-6640 Sealant -
B - Guide Studs
M8 by 40 mm 2
C - Alignment Tool 1
- Bolts
M10 by 50 mm 3
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Ensure that wiring harness are correctly routed and the cable straps are not over tightened. Over tightening of the cable straps will damage the wiring harness convoluting.
Ensure that the front housing is clean and free from damage. If necessary, replace the front housing.If necessary, install blanking plugs to a new front housing. Use Tooling (A) to seal all D-plugs.
Illustration 7 g06271519
If necessary, replace the dowels in the cylinder block.
Illustration 8 g06271522
Illustration 9 g06271523Note: Ensure that the two circular tabs on the gasket are engaged in the two holes in the cylinder block. Ensure that the dowel in the cylinder block is engaged on the gasket.Install Tooling (C) to the cylinder block.
Illustration 10 g06271525
Illustration 11 g06271529
Illustration 12 g06271530Refer to Specifications, "Front Housing" for more information.Remove Tooling (C) from the cylinder block.
Illustration 13 g06271542
Illustration 14 g06271543
Illustration 15 g06271546End By:
Install the gear group (front).
Install the water pump.
Install the fuel injection pump.
Install the auxiliary water pump.