PUMP GP-GR 3 BSC 20R7460 - Caterpillar

AFFECTED PRODUCT
Model Identification Number
D6N LGP OEM SC600100-00117
D6N LPG PBA00200-00439, 441-614, 616-851, 853-1082, 1084-1238, 1539-1788
D6N XL PER00101, 200-220, 222-306, 308-545, 548-629
PARTS NEEDED
Qty
Part Number Description
1 3917037 CONT GP -B
1 4448027 SFWR GP-A4014
In order to allow equitable parts availability to all participating dealers, please limit your initial parts order to not exceed 1% of dealership population. This is an initial order recommendation only, and the ultimate responsibility for ordering the total number of parts needed to satisfy the program lies with the dealer.
ACTION REQUIRED
Refer to the attached Rework Procedure.
SERVICE CLAIM ALLOWANCES
Product smu/age whichever comes first Caterpillar Dealer Suggested Customer Suggested
Parts % Labor Hrs% Parts % Labor Hrs% Parts % Labor Hrs%
0-2000 hrs,
0-24 mo 100.0% 100.0% 0.0% 0.0% 0.0% 0.0%
This is a 2.0-hour job
PARTS DISPOSITION
Handle the parts in accordance with your Warranty Bulletin on warranty parts handling.
Rework Procedure
Use the following rework procedure to replace the operator message display.
1) Ensure the machine is parked in a safe area for working, switch main battery disconnect switch to the off position.
2) Remove the operators foot rests, two Truss head M10x1.5x25mm fixings in the foot pads and two Truss head M6x1x20mm fixings on the bottom cross bar.
3) Remove the 6 off Truss head M6x1x20mm instrument panel fixings. Refer to Image 1.1.1.
4) Pull the instrument panel into the cab.
5) Unplug connector1 from the display module. Refer to Image 1.1.2.
6) Remove the 8 off M5x0.8x12mm display fixings and remove the display from the instrument panel.
7) Fit new messenger 2 display tighten diagonally the 8 off M5x0.8x12mm display fixings to 1.7,+ 0.34, -0 Nm.
8) Re-connect connector 1.
9) Re-position the instrument panel in the cabin; tighten 6 off Truss head M6x1x20mm instrument panel fixings to 6 Nm.
10) Replace the foot rest assembly, tighten the two Truss head M10x1.5x25mm fixings in the foot pads to 55+/-10Nm. The two Truss head M6x1x20mm fixings on the bottom cross bar to 6+/-1Nm.
11) Flash the new monitor with software.
12) Test all message display functions and return to service.
Image1.1.1
Image1.1.2