PUMP GP-GEAR 2146868 - Caterpillar

2146868 PUMP GP-GEAR Caterpillar parts 906

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA2146868
214-6868
2146868

Weight: 13 pounds 6 kg.

Buy PUMP GP-GEAR 2146868 Caterpillar genuine, new aftermarket tractor parts with delivery
COMPACT WHEEL LOADER,

Compatible equipment models: 2146868:

COMPACT WHEEL LOADER 906 Caterpillar

Number on catalog scheme: 1

Caterpillar 2146868 Parts scheme PUMP GP-GEAR

For full view, you need register

Information:

Which Generate This Code:The signals from the engine speed/timing sensors indicate that the expected position of the camshaft is incorrect with respect to the crankshaft. Or the polarity of the wiring to one of the speed/timing sensors is reversed. System Response:The Electronic Control Module (ECM) will log the diagnostic code.The ECM sets engine timing calibration to zero degrees.
The engine may misfire.
The engine may experience low power and/or reduced speed.
The engine may experience increased exhaust emissions and/or white exhaust smoke. Test Step 1. Check the Installation of the Speed/Timing Sensors
Visually inspect the sensors for correct installation:
Ensure that the sensor mounting flanges are seated onto the surface of the engine.
Ensure that the locating notch on the flange of each sensor is oriented correctly.
Ensure that the sensor brackets are not bent or broken. Ensure that the brackets are securely holding the sensor in place.
Ensure that the sensors are tight in the housing bore. If a sensor is loose in the bore, check the condition of the sensor O-ring seals. Ensure that the seals are not missing. Also, inspect the seals for damage.
Check for the correct installation of the sensor connectors. Ensure that the electrical connector is securely latched. Check for the correct polarity in the wiring at each sensor connector and at the ECM connector.
Ensure that the harness is properly secured, and ensure that each tie-wrap is placed in the correct location.Expected Result:The sensors, the connectors, and the wiring are correctly installed.Results:
OK - The sensors and the harness are OK. The problem is not with the sensor or the harness. There may be a mechanical problem with the engine front gear train. Proceed to Test Step 2.
Not OK - A problem has been identified with the installation of the sensors and/or the harness.Repair: Correct the problem that has been identified. Replace parts, if necessary. Ensure that the diagnostic code is no longer active.A timing calibration is necessary after this diagnostic code has become active. Refer to the diagnostic functional